SPECIALS

Electric-hydraulic brake actuator lets you use an electric brake controller from inside your vehicle to adjust and control your trailer's hydraulic brakes. Gives you greater control over your trailer's brakes than that provided by standard hydraulic actuators. Sealed, extruded, anodized aluminum housing (not cast or plastic) to prevent corrosion. Details/Specs: Dimensions 11.8inch long x 3inch wide x 7.3inch high Trailer mounted 12 V DC operation Requires in-cab controller Provides 1600 PSI for any trailer configuration with disk brakes and 1-3 axles Uses DOT 3 or DOT 4 brake fluid Meets all DOT regulations & complies with CFR-393 braking requirements 2 year warranty from date of purchase Manufacturer: Hydrastar Manufacturer Part Number: HBA-16 Our Part No: 21-352-1  

Read more less

Electro/Hydraulic brake actuator provides 1000 psi of pressure for 1-3 axles equipped with drum brakes. Sealed housing provides a weather tight seal. Large reservoir capacity reduces the number of fill-ups required which reduces the bleed time as well as the risk of running the reservoir dry during brake bleeding. Aluminum enclosure provides anti-corrosive protection and prevents the elements from affecting reliability while the finned housing design dissipates heat efficiently. Proportional pressure output to the brakes corresponds to voltage output of the brake controller for smooth, reliable braking. Details/Specs: Provides 1000 PSI of pressure For single, tandem, and triple axle trailers with drum brakes Dimensions: 10.5" L x 5.5" W x 7" H 12V DC operation requires 4-wire hookup & at least 9 amp break-away kit Uses DOT 3 or 4 brake fluid, holds 40 cubic inches (0.7 qts) Meets or exceeds all DOT regulations and federal braking requirements Manufacturer: DexterPart No: K71-650-00

Read more less

Complete Brake Assembly - 12" x 2" Electric 7K Brake Assembly - Dexter Specify Left (K23-180-00) or Right (K23-181-00) Mounts to 5-hole axle brake flange. Note: Specify left or right side assembly.

Read more less

Manufacturer: Dexter Manufacturer's Part Number: 008-219-13 Brake hub & drum for 7k axles w/8 on 6 1/2" bolt pattern and 9/16" studs. For use with 12" x 2" electric or hydraulic brakes. Bearings (not included): 25580 - inner, 14125A - outer Capacity: 3,500 lbs. DOES NOT include bearings, seal, lug nuts, nor grease cap but has races and studs pressed in.

Read more less

HUB & DRUM KIT 7K - FULL GREASED - 8 on 6.5" bolt pattern  9/16" STUD Included 25580 Inner and 14125A Outer BearingsIncludes hub, inner and outer bearings, grease seal, grease cap, grease cap plug, cone nuts, spindle washer, tang washer, and spindle nut.

Read more less

Manufacturer: Dexter Manufacturer's Part Number: 008-219-04 Brake hub & drum for 7k axles w/8 on 6 1/2" bolt pattern and 1/2" studs. For use with 12" x 2" electric or hydraulic brakes. Bearings (not included): 25580 - inner, 14125A - outer Capacity: 3,500 lbs. DOES NOT include bearings, seal, lug nuts, nor grease cap but has races and studs pressed in.

Read more less